(1.)The seat pan is made of fiberglass in a clamshell-type mold and when completed, the pan cured for at least an hour before the seat could be built.(1.)The seat pan is made of fiberglass in a clamshell-type mold and when completed, the pa (2.)Once the seat pan was ready to be built, a specially formulated gel pad was inserted on top of the pan.(2.)Once the seat pan was ready to be built, a specially formulated gel pad was inserted o (3.)The seat pan and gel insert were then put into the two-piece foam mold and clamped shut.(3.)The seat pan and gel insert were then put into the two-piece foam mold and clamped shu (4.)The liquid seat pad foam material was pumped into the mold, where it set up into a solid within 15 minutes.(4.)The liquid seat pad foam material was pumped into the mold, where it set up into a sol (5.)After the foam set up, the pan was pulled from the mold and checked for quality control.(5.)After the foam set up, the pan was pulled from the mold and checked for quality contro (6.)Victor started his part of the build by smoothing the sides of the seat where remnants of foam were built up.(6.)Victor started his part of the build by smoothing the sides of the seat where remnants 1 | 2 | » | View Full Article By Jeff G. Holt Enjoyed this Post? Subscribe to our RSS Feed, or use your favorite social media to recommend us to friends and colleagues!
